...
This article describes how to configure an LACP trunk between an XS or GS-45xx series switch and an LCOS LX access point.
Hinweis |
---|
Please note, that LX-6500(E) access points operated with PoE in 802.3at mode limit the port speed of ETH-2 to only 100 MBit (ETH-1 - 2,5 GBit). Due to the diverging port speeds (ETH-1 - 2,5 GBit und ETH-2 - 100 MBit) LACP cannot be used in such a scenario! LANCOM LX-6500(E): Improvements to PoE power management as of LCOS LX 6.14 in IEEE 802.3at operation |
Info |
---|
In contrast to a Static Trunk the feature LACP supports a dynamic negotiation, thus enabling the Trunk to remain active when a line fails. LANCOM Systems therefore recommends to always use LACP when combining switch ports to a trunk. To ensure optimal redundancy, it is recommended to connect the access points via a power supply unit as well as via PoE (if PoE is supported by the switch). If the power supply unit fails, a GS-45xx series switch seamlessly takes over the power supply via PoE. |
...