...
The port speed of the switch ports used for LACP must be limited to the maximum supported speed of the access points (see step 2.12).
| Info |
|---|
Skip step 1.2 in the following cases:
|
...
1.2.2) Select the ports, LACP was configured for in step 1.1 and, under Mode, select the highest port speed which is supported by both ports of the access point (see step 2.12). In this example the option 1Gbps FDX has to be selected for a port speed of 1 GBit.
...
2) Configuration steps on the access point:
2.1) Configuring LACP on the access point:
2.1.1) Go to the menu Interfaces → Port config → LACP.
2.1.2) Edit the existing entry for the Bundle-0 and for Operating select the option Yes.
2.1.3) This concludes the configuration of LACP on the access point. Write the configuration back to the device.
2.2) Setting the port speed of both access point ports to the same value (only required on access points with different Ethernet port speeds):
As some LCOS LX access points support different port speeds (e.g. LX-6400 with ETH1: 2.5 GBit and ETH2: 1 GBit), the speed must be set to the highest value supported by both ports (for an LX-6400 this is 1 GBit). Also, some GS-3xxx switches only support a maximum of 1 GBit, so that in these cases the port speed on the access point has to be set to 1 GBit.
| Info |
|---|
Skip step 2.1, if you are using an access point, where both ports support 2.5 GBit and also the ports on the switch support 2.5 GBit (e.g. the LX-6500 has two Ethernet ports with 2.5 GBit). |
2.12.1) Connect to the access point via LANconfig and go to the menu Interfaces → Port config → Ethernet ports.
2.12.2) Edit both ports and select the option 1000FDX.
2.2) Configuring LACP on the access point:
2.2.1) Go to the menu Interfaces → Port config → LACP.
2.2.2) Edit the existing entry for the Bundle-0 and for Operating select the option Yes.
2.2.3) This concludes the configuration of LACP on the access point. Write the configuration back to the device.