Description:
The following table shows which WLAN Controller features are suppported by LCOS LX 5.36 and how it behaves when a feature is not supported.
Section | Feature | Supported? | Remarks |
---|---|---|---|
WLAN Controller → General | Password synchronization | Yes | |
WLAN timing | Yes | ||
Using alternative WLAN Controllers | No | ||
WLAN Controller → Profiles → Logical WLAN networks (SSIDs) | LAN at AP with VLAN tagging | Yes | |
WLC-Tunnel | Yes | Supported as of LCOS LX 5.32 Rel in combination with LCOS as of version 10.42 RU3 on the WLAN Controller | |
Encryption - WPA2 | Yes | ||
Encryption - WPA3 | Yes | ||
Encryption - Enhanced-Open | Yes | ||
Encryption - Enhanced-Open-Transitional | No | ||
802.1X | Yes | ||
RADIUS profiles | Yes | ||
2,4 / 5 Ghz mode | Yes | If a setting is selected, which is not supported by the access point (e.g. 802.11ax in combination with an LW-500), a profile error will be displayed and the WiFi won't be broadcasted on the affected access point. | |
Standalone operation | Yes | ||
Hotspot 2.0 / 802.11u | No | ||
OKC | Yes | ||
MAC check | Yes | ||
RADIUS accounting | Yes | ||
Inter station traffic | Yes | ||
Fast Roaming | Yes | ||
Configurable base rate | No | ||
Client Bridge Support | No | ||
Bandwith limit per SSID | Yes | ||
Bandwith limit per Client | Yes | The Client TX bandwith limit does not work in combination with a WLC-Tunnel. | |
Maximum count of clients | Yes | ||
Min. Client signal strength | Yes | ||
Client disassocation signal strength | No | ||
Location Based Services (LBS) | No | ||
Convert to unicast | Yes | DHCP packets cannot be converted by LCOS LX. Therefore with the setting DHCP the Unicast conversion in LCOS LX is deactivated and with DHCP and multicast only Multicast packets are converted to Unicast. | |
Transmit only Unicasts | No | Broadcast packets cannot be discarded by an LCOS LX access point. | |
U-APSD | Active permanently | ||
Encrypt mgmt frames | Yes | ||
WLAN Controller → Profiles → Physical WLAN parameters | Country setting | Yes | |
2,4 GHz mode | Yes | ||
5 GHz mode | Yes | ||
5 GHz Sub-bands | Yes | ||
DTIM period | No | In LCOS LX the DTIM period is set the fixed value 1. | |
Background scan interval | No | ||
Antenna gain | Yes | ||
Tx power reduction | Yes | LCOS LX berechnet die Reduktion immer ausgehend von 30 dB Sendeleistung. Dadurch ergeben sich für die verschiedenen Frequenzbänder und die Unterbänder im 5 Ghz Band folgende Konstellationen:
| |
Activate the VLAN module | - | Die Aktivierung des VLAN-Moduls ist bei LCOS LX nicht erforderlich und hat keine Auswirkungen. | |
ARC: Client Steering | Yes | LCOS LX unterstützt nur AP-basiertes Band-Steering. Bei Verwendung der Optionen Ein und Client-Management wird in LCOS LX das AP-basierte Band-Steering aktiviert. | |
ARC: Adaptive RF Optimization | No | ||
QoS according to 802.11e | Active permanently | ||
Activate Indoor only mode | Yes | ||
Report seen unknown clients | No | ||
WLAN-Controller → Profile → Erweiterte Profile | Geräte-LED-Profile | Yes | |
AutoWDS | No | ||
LBS - Server | No | ||
Wireless ePaper | No | ||
Wireless-IDS | No | ||
WLAN-Controller → AP-Update | Firmware-Management (AP-Update) | Yes | |
Skript-Management (AP-Update) | No | ||
WLAN Controller → Stations/LEPS | LEPS-U | Yes | |
LEPS-MAC | Yes | ||
Miscellaneous | ARC: Funkfeldoptimierung | No | |
Konfigurations-Verzögerung (WLAN-Profile) | No | ||
Absende-Adresse (RADIUS-Profile) | No | ||
IP-Parameter-Profil (AP-Konfiguration) | Yes | ||
Antennengruppierung (AP-Konfiguration) | No |